- This topic has 1 reply, 2 voices, and was last updated 11 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi, yesterday i got my Eggbot board ( exactly this one : http://www.watterott.com/de/EiBotBoard ).
The firmware update etc worked fine but when i try to adjust the vref of the the stepper drivers I realised that in every position of the poti, vref stays at ~2V (measured on ground and the vref pad near to the poti). Driving the steppers with this config heatens the motors and the drivers too much :( Is there a design error in the version of the board?!My second problem is the servo which isn’t working. Sending a command to move it lets the servo make noise but it doesnt move…
Can anyone help me please ?
Thx in advance
First, be sure that you’re measuring this voltage at test point TP3.
While I don’t think that there’s a design error, it sounds like you may have received a board with a bad pot or some other kind of fabrication error. You should probably contact the store where you bought it, to arrange for an exchange.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
