Bulbdial Clock never worked.

Home › Evil Mad Scientist Forums › Clock Kits › Bulbdial Clock never worked.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 20, 2013 at 7:31 pm #20224
    Tornadoe12
    Participant

    I got a bulbdial clock kit for christmas and I got a bit ahead of myself and put in the chrono dot before setting any leds. my clock hasn’t lit up. There is one possible other thing. I need to know if the orientation of a crystal has anything to do with this?

    May 20, 2013 at 7:33 pm #21335
    Windell Oskay
    Keymaster

    Putting in the Chronodot too early should not cause any problems, and the orientation of the crystal does not matter. 

    What stage of construction are you at, presently?
    February 13, 2014 at 5:52 pm #21336
    Tornadoe12
    Participant

    I’m at the stage where you have to set up the first ring of lights. But then I went ahead and built the rest of it hoping it would work. Nothing. I’m going to try to upload the firmware again to see if that helps. I’ve checked all solder joints and tried and tried, but have come up cold. 

    February 13, 2014 at 5:54 pm #21337
    Tornadoe12
    Participant

    Should there be a capacitor at C4? I don’t have one there and I didn’t receive the part with the kit so I’m assuming not. Uploading the firmware again did not do anything either.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.