- This topic has 4 replies, 4 voices, and was last updated 11 years ago by .
-
Posts
-
Hello everyone!
I am experiencing some difficulties with eggbot.. :S It seems like the board can’t give orders to both motors. Both motors work, I tested that by plugging the egg-rotating mottor to the pen-rotating motor slot on the board. It seems that the board can only move any motor connected to the egg rotating slot, but not on the pen rotating one.
Is something wrong with the board or am I not calibrating something correctly?I have checked the current with the poteniometer as the instructions say. The motors work very nice with a little current.
That definitely sounds like a problem with one channel of the EBB. Please contact our store directly about getting a replacement: http://shop.evilmadscientist.com/contact
I have the exact same problem, so it might be worth looking into. Thanks for the link!
Hi spacekh-
I think you contacted us via email about your issue, which appears to be something entirely different. I’ve followed up with via email.
- You must be logged in to reply to this topic.
