- This topic has 2 replies, 3 voices, and was last updated 8 years, 5 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Has anyone out there been brave enough to go this route when updating / programming their clock?
I tried it, everything seemed to compile after adding a couple of “const”s to some of the library definitions, but I couldn’t get it to upload.
There’s a new Sanguino board definition here: http://lauszus.github.io/Sanguino/ that I installed and was able to select it in the IDE, and I modified the boards.txt file to have right right upload rate, but it’s still giving me the “stk500_getsync() not in sync: resp=0x00” errors.Which type of programmer are you using, and which firmware are you using? (That is, if using Arduino-style bootloader firmware, is it one based on the v1 or v2 firmware?)
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
