- This topic has 4 replies, 3 voices, and was last updated 8 years, 8 months ago by .
Viewing 5 posts - 1 through 5 (of 5 total)
-
Posts
-
I wonder if anybody has found a good way to keep the eggbot servo wires under control. I’m always afraid they’ll touch the still-wet ink and ruin a print.
I’ve currently got mine zip-tied to the lowest end of the proximal pen arm, but I bet some smart person out there has found a better way. What is it?
Which model of EggBot?
I usually route the servo cable through the mounting screw hole on the servo motor; the one opposite the mounting hole that holds it in place. I don’t think that I can recall ever having a print actually ruined by a servo cable smear– even when using slow-drying finicky ink.
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
