no, it doesn’t respond at all

Yes, I found a cold solder joint and resoldered it. Now the pen is working properly, but the motors are “jerky”, like very low resolution. Is there a setting for this?

I assume it was one of the earliest models. The board was cracked along with the frame. I am now printing a frame from thingiverse to try to put these motors and the new board on because it is falling apart. I think the previous person got it from someone else too because it looks like these aren’t the original motors. I tried out the motors on a ramps 1.4 setup and they run smooth there, but seem to be running full step with the eggbot board. By the time I figure this out, I probably could have just bought the new kit. I should have the new frame printed in a couple hours and see what happens then.

No, it is fiberglass, but it looks like it sat somewhere very dirty and got wet or soaked with something so the fiberglass was falling apart. I bought the new board, checked the motors (with a ramps board), so I know that much is ok. I think the rc servo is ok or at least seems to work. There isn’t that much to this thing, I set the current (actually might need a little bit more), but the motors still seem to cog very hard like the board is sending full steps. I have checked the motor wiring by the elimination method so I am pretty sure its not that. Is it possible I have the wrong driver installed?