Scaling issue

Home › Evil Mad Scientist Forums › AxiDraw › Scaling issue

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 26, 2020 at 11:31 pm #28706
    Fabrice
    Participant

    Here is the settings window for my design in inkscape.

    And here is the resulting plot, where the plot came outside of the page and failed.

    I wonder why the plot was drawn so far down from the origin point. But maybe it’s a scale issue? I did have margins all around the design…

    October 26, 2020 at 11:35 pm #28714
    Windell Oskay
    Keymaster

    It looks like it plotted at approximately the right scale, and it did plot. Can you say what it is that failed? Was there some kind of an error?

    If you are not sure that the scale is coming through correctly, I would suggest to try plotting a square of (say) 10 cm square, which you can measure and verify with the ruler.

    With respect to the centering, it looks most like the initial pen position was not set correctly.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.