I just finished putting together my Eggbot found on Thingiverse. I’m now trying to get the software part of the project working. I have installed the firmware from the project on my Arduino via the Arduino IDE. If I plug the Eggbot into my computer the servo goes up and down. I’m hoping that’s a good sign. I have taken care of the dialout requirements. This was something I needed to do previously to communicate with my Raspberry Pi Pico. So I know I have this part of the project correct. I can also see the Arduino in my serial list when I run ls /dev/tty*. When running that command I can see that the Arduino is running on /dev/ttyACM0. I have installed the Eggbot extension into Inkscape following the directions. The Eggbot extension is in Inkscape but when I try to run any commands I get back a message the Inkscape cannot find the device. I have read that I might have to edit a file and comment out some lines of code but when I look into following those directions the lines to comment no longer exist. I’m not sure what to do next and what directions to follow. I would love to have this working for my kids for Easter so any help would be wonderful! Thank you very much.