- This topic has 8 replies, 2 voices, and was last updated 10 years, 6 months ago by .
-
Posts
-
Hi,
I’m looking for a little expert advice. I plan on using an ‘art controller’ to turn on a computer monitor in a arcade cabinet. The main PC motherboard is plugged into a power strip that powers on outlets after the PC is turned on. The monitor has a momentary type switch that requires a temporary contact closure. What I’m looking for is how to setup the ‘art controller’ to act as a ‘one shot relay’ to power on the monitor once it is energized. Anyone have any ideas how to configure this correctly before I receive it next week? I will be soldering two wires to the momentary switch inside the monitor before the ‘art controller’ arrives in the mail. Thanks.Use the “trigger @ reset” option, to have it trigger automatically when it first gets power, and do not add any of the other optional jumpers.
Can you please say what wasn’t clear about that in the instructions?The “trigger @ reset” option does not change whether or not it is a “one shot” — it just makes it so that it triggers automatically (as though you had pressed the button) when the Art Controller first turns on.
Yes, you can set the dip switches for a 6-second activation period. (It does not fully “reset” after that– it just goes idle to wait for the next trigger.)
The Art Controller has an on-board voltage regulator, and is designed that you can run it straight from 12 V (using the yellow (+12 V) and black (0 V) wires from a PC power supply. If you would prefer to drive it directly from 5 V (using the red wire (+5 V) and black (0 V) from a PC power supply), you can do that, but a little care is required. See our instructions about “omitting the voltage regulator” on this page: http://wiki.evilmadscientist.com/Art_Controller_Hardware_Variations Awesome!
- You must be logged in to reply to this topic.
