- This topic has 0 replies, 1 voice, and was last updated 7 years, 10 months ago by .
Viewing 1 post (of 1 total)
-
Posts
-
We just built a spherobot at our makerspace. it seems to always over rotate the print. I mean by this there is an overlap by about 1/2 inch on a rotation. Is there a place to adjust the amount of steps per rotation? is it the example prints we are using? also all of the circles are ovals. I figure this is probably connected.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
