- This topic has 1 reply, 2 voices, and was last updated 4 years, 3 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
This is a new assembly. The blue ring tested fine but the bottom quadrant of the green ring is skipped in test mode. Seems like an addressable problem but I could use some help getting started.
The six “lowest” LEDs on the green ring are numbered and positioned:
* D93
* [LED10]
* D39
* [LED3]
* D83
* [LED8]
* D38
* [LED6]
* D73
* D37If those six LEDs are the ones not lighting but you do not have any issues on the blue ring, it suggests that your connection to the “LED3” ring has a problem. Check carefully the soldering at pin LED3 as it enters the green board.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
