- This topic has 2 replies, 2 voices, and was last updated 7 years ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hello all
I am 3D printing a replacement for the wooden pen holder. The servo is on the other side of the rotating part, therefore pen up/down is inverted. I don’t see an option in the control extension… Can anyone help me please? TIAThe option is right in front of you: You can set either the pen-up or pen-down height to be the higher number.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
