- This topic has 1 reply, 2 voices, and was last updated 6 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I can get connection with the inkscape app and move the servo(pen) up and down but I can not get any movement on the steppers when I use the manual tab or if I try to plot. When I enable the steppers on the manual tab neither stepper seems to energize.
I believe i have the steppers hooked up to the shield properly since I am using the same shield on the Makeangelo drawbot, but I could have then screwed up. Any help would be appreciated.
I have an Arduino Leonardo with a MH Electronics motor shield. I have Ejjduino_Arduino loaded on the Leonardo and I am running inkscape .91 with release 2.4.0 of Eggbot control installed.
CurtSorry, can’t help you with that. That’s not a hardware configuration that EggBot software supports.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
