blin

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 13, 2017 at 4:19 pm in reply to: Drawing Diagonally when using CNCServer #22845
    blin
    Participant

    I am using Postman to get and put the “botType,” but even though I changed the botType to axidraw, it is still drawing on a diagonal. Is there anything else we need to change it to AxiDraw mode?

    I am also looking at the RoboPaint GUI. It appears that there are only two modes: WaterColorbot and Eggbot.

    February 13, 2017 at 2:18 pm in reply to: Drawing Diagonally when using CNCServer #22843
    blin
    Participant

    I have changed the variable to axidraw, but it is still drawing on a diagonal. Also, when I go to localhost:4242, it still displaying the WatercolorBot set-up.

    December 9, 2016 at 11:45 pm in reply to: Vertical Slide not lowering #22717
    blin
    Participant

    Will do!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)