clocey

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
December 22, 2017 at 10:34 pm in reply to: Failed to connect to EggBot. :( #23004

clocey
Participant

in device manager it shows “Arduino Uno (COM3) under ports

December 20, 2017 at 1:38 am in reply to: lxml wrapper needed after upgrading inkscape to 0.92 #23002

clocey
Participant

it is the arduino. it disappears when I unplug it and reappears when plugged back in. I have tried two different USB cables. I also tried a different uno and it came up the same. I am guessing this has to do with the ubw driver

December 20, 2017 at 1:18 am in reply to: lxml wrapper needed after upgrading inkscape to 0.92 #23000

clocey
Participant

I installed .91 and I am back to where I was when I upgraded to .92. I can see the arduino uno in device manager – USB-SERIAL CH340 (COM3) but when I try to connect using the eggbot extension in inkscape I get “Failed to connect to EggBot. :(“

December 20, 2017 at 1:01 am in reply to: lxml wrapper needed after upgrading inkscape to 0.92 #22999

clocey
Participant

I uninstalled .92 and I will see if I can find .91
Thanks
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)