[dddaaannn]

Hi Windell –

Thanks for the advice!  Good news: I think I just had the test circuit hooked up incorrectly.  :)  I verified the placement and orientation of all of the parts, examined the joints, and went back to my breadboard and started to wonder if I misread the pin assignments.  I hooked it up fresh and it works now.  The diagram looks fine, and I’m not sure where I messed it up, so no further feedback.

I’m very excited about this kit and the documentation.  High quality, easy build, and very educational.  Thanks again!

— Dan

[dddaaannn]

Oh, and a quick question while I’m here: The test circuit included in the instructions calls for a 1uF cap.  Is it OK to substitute an electrolytic here?  I assume it’s usually OK as long as the behavior of the circuit doesn’t depend on storing charge of different polarities at different times.  I just don’t have a 1uF ceramic at the moment.  (I ordered more stock recently.)

Thanks again!

— Dan

[dddaaannn]

Good advice, thanks Ugi!

— Dan

[Author]

Posts