infra

Forum Replies Created

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • October 24, 2012 at 7:36 am in reply to: EBB after reprogramming #20949
    infra
    Participant

    I found the mistake
    there was not bootloader in a new processor
    from here I downloaded it
    thanks
    October 23, 2012 at 8:11 pm in reply to: EBB after reprogramming #20948
    infra
    Participant
    I was building other ebb2.1 board
    pic go shopping microchip

    http://www.schmalzhaus.com/EBB/  

    EBB Version 2.1

    this does the same 
    firmvare 
    pours pickit2
    only the 3.3v led lights the others not
    mplab programming okay
    Windows xp does not recognise 
    new microcontroller not bootloader
    what kind of bootloader is needed into
    him
    where can be found?
    October 17, 2012 at 11:53 am in reply to: EBB after reprogramming #20946
    infra
    Participant

    pic usb pin low level

    October 17, 2012 at 11:52 am in reply to: EBB after reprogramming #20945
    infra
    Participant

    pic osc pin clock  oscilloscop check okay

    October 17, 2012 at 11:50 am in reply to: EBB after reprogramming #20944
    infra
    Participant

    pic pin osc ok pic running

    pic processor the usb  the pc does not communicate
    October 16, 2012 at 5:43 pm in reply to: EBB after reprogramming #20943
    infra
    Participant
    only 3.3v led on
    October 16, 2012 at 5:41 pm in reply to: EBB after reprogramming #20942
    infra
    Participant
    programming mplab pickit2 
    okay
    mplab cheque okay
    pic processor the usb  the pc does not communicate
    October 16, 2012 at 5:27 pm in reply to: EBB after reprogramming #20941
    infra
    Participant
    programming mplab pickit2
    okay
    mplab cheque okay
    October 16, 2012 at 5:21 pm in reply to: EBB after reprogramming #20939
    infra
    Participant
     hardware problem
    I built it out of components now öszze but I cannot resuscitate it
    pic processor the usb  the pc does not communicate
    pc not hardware
    usb led not light
    October 16, 2012 at 5:13 pm in reply to: EBB after reprogramming #20937
    infra
    Participant

    I soldered I was building hardware 2.1

    firmware mplab pickit2
    okay
    Windows new hardware does not hit
    home
    only the 3.3v led on
    somebody else
    does not happen
    October 16, 2012 at 4:57 pm in reply to: EBB after reprogramming #20935
    infra
    Participant
    I built it eggbot 2.1 .
    firmvare
    pours pickit2
    only the 3.3v led lights the others not
    mplab programming okay
    Windows xp does not recognise
    it
    usb driver installed
    eggbot connects pc
    only the 3.3v
    led lights and nothing happens
    error to search where
    thank you
  • Author
    Posts
Viewing 11 posts - 1 through 11 (of 11 total)