izambard

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Stepper Problems #22363
    izambard
    Participant
    Thank you Windell
    The mystery has been solved.
    I have built my own machine from scratch and the motors that I used (nema 17) had exactly the same colored leads as those shown on the EggBot web site. I had wired the motors as per the instructions shown in the Eggot assembly PDF.
    I have since discovered that although my lead colors where the same the actual wiring was different.
    The motors now run as smooth as silk.
    I am now smiling and thank you for your attention.
    in reply to: Stepper Problems #22361
    izambard
    Participant

    The Egg motor begins with a few steps in one direction and the same few steps in the opposite direction. it sounds as if the motors are cogging. I do not get any sort of “sensible” response from either of the two motors. 

    in reply to: Stepper Problems #22360
    izambard
    Participant

    When I attempt to adjust the current I either get a continuous rotation or the same bad behavior.

    in reply to: Using Eggbot with a CNC machine as 4th axis #22294
    izambard
    Participant

    Mach 3 does support a 4th axis and the setup is quite simple. Basically all that is required is a forth stepper to provide the rotation and a chuck to secure the work piece.

Viewing 4 posts - 1 through 4 (of 4 total)