[jdmartin]

That was the problem…..I had inadvertently backed out to the Plot tab….when I stay in the layers tab and “apply” each layer change from there,  it works perfectly !!  Thank you Dan and Windell for replying to my post…

Jim

[jdmartin]

I’m using an svg file that was created by Robogenius, specifically the “Oscar the Grouch” file that I downloaded from Thingiverse….

Let me check again to make sure that I did in fact click the Apply when changing layers,  but I know when I did the first plot test,  I didn’t go into the layers tab,  it was defaulted to layer 1,  and that’s when it printed the entire design without stopping…

[jdmartin]

Received the kit,  and aside from having to re-tap three of the threaded angle brackets,  everything else went together exactly as described in the instructions.  No problems at all with build….

I will be hooking up to the computer tomorrow for the initial setup and first trial run….I’ll post the results here.

Thank you for the quick shipment,  and a beautifully designed kit.

Jim

[jdmartin]

Sorry ’bout that…..

This should be more along the lines of true vector clip art…

[Author]

Posts