MattInLA

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Servo moving by itself #22584
    MattInLA
    Participant

    I finally got a chance to try the new power supply and it appears to be working properly. Thanks for all your time!

    -Matt
    in reply to: Servo moving by itself #22582
    MattInLA
    Participant

    Tried turning current up but still only get results like in the second video posted above. When doing nothing, the motors just slightly click. Still not getting warm. Thanks.

    in reply to: Servo moving by itself #22580
    MattInLA
    Participant

    No, the motors have been powered for more than 20 minutes now and they are cold.

    Did the preflight again. The line on the Y motor seemed really tight so I gave it a little more slack. Both seem to be moving freely and smoothly now when turned. I did notice a very slight gap (about 2mm) at the top left X endstop.
    Even so, it still doesn’t work.
    in reply to: Servo moving by itself #22578
    MattInLA
    Participant

    Thanks.

    – The servo motor doesn’t appear to be getting hot.
    – The steppers don’t work properly, even when the servo is unplugged from the EBB. After trying to run a job the X stepper seems to be move very slightly but only as long as the USB is plugged in.
    – I did trying adjusting the current to no avail.
    I’m happy to make any necessary repairs or adjustments. Just point me in the right direction. Thanks so much.
    -Matt
Viewing 4 posts - 1 through 4 (of 4 total)