[rbtroj]

Thanks, Windell. The chips are all seated well so I will see if I can re-do the joints on the sockets.

[rbtroj]

Interesting … received my replacement chips and added them to the board one by one as I tested. No difference – however, I pushed down on the LED driver #2 (inner one of the two on the left side of board) and the blue LEDs on the right side of the board barely lit (but they lit). Maybe I need to resolder the socket?

I have not uploaded any sketches because, well … I can’t figure out how. My Arduino IDE does not seem to recognize the Peggy 2 board.

[rbtroj]

I had it on the external plug that was optional with the kit.

I will try uploading different sketches once I get it going again. 

Thanks for your help!

[rbtroj]

Good questions.

2. The board is P2 config
1. I have not done any programming as I had thought the default was to light all the LEDs as a test (is that wrong?)

If you think I should upload a new sketch I will … Just as soon as I receive my replacement demultiplexer since I just broke three pins removing it :(

[Author]

Posts