[Carl]

Alright, after perusing the Bulbdial code again, I see where the clocks serial port is setup at 19200 baud and the time header needs to be a byte equivalent to 255 (FF). the current sample Process Sketch has the baud set at 9600 and is sending a time header of “T”. after modifiying the sketch a little it know syncs up to the bulbdial.

I’ve uploaded the modified Process sketch to use to send the time to the bulbdial clock. hope this helps other.

https://www.dropbox.com/sh/fxomey4iiwi19tu/AAAjCjVYhKgml3QgB_xOlVSJa?dl=0

[Carl]

Thanks for the reply, I can confirm that the com port im using is correct, I see the tx/rx led’s illuminating when I try to send data. the Process sketch seems to be using a baud rate of 9600, I’ve tried changing that to 14400 and 115200 with no luck. not sure what the actual baud rate is for the clock.

[Author]

Posts