Forum Replies Created
-
AuthorPosts
-
Tatien3DParticipant
About StippleGen I´m going to print somethin more..I´m not sure that I´m following the steps that you say. I´ll tell spu the final result.
I´m going to try your recomenddation about the hatch fill.Thank you for all.Tatien3DParticipantAnd this is the problem with hatch fill. I can´t delete the line that appears in the middle of her face
Tatien3DParticipanthttp://overpic.net/viewer.php?file=xq237yczog02ohs9lh0w.png
The other post doesn´t works. Perhaps this!Tatien3DParticipant
I hope that it works!Tatien3DParticipantWhen I use the “hatch fill” I work only with one layer, and the others are hiding (with the eye closed) but the lines continue to apear in the wrong place.
Tatien3DParticipantI have the photo in my PC
Tatien3DParticipantI´m so sorry. I don´t know how to post a photo because when I try to insert it say “insert URL”
Tatien3DParticipantNo. The problem is that I made the drawing with a photo with stiplegen2 and export it to Inkscape. I see in Inkscape the eyes black but when I print the eyes are white (with less concentration of points, so they looks white)
On the other hand, I open a photo of a face with Inkscape and vectorice in gray scale. In eggbot contributed I make the layers. I want to fill the regions and use the “hatch fill” but some lines fall outside the region and I can,t delete. When I use the rubber all the image disappears!Thank you againTatien3DParticipantThank you for your patience and your answers.
I´ve solved the problem with the pen. I made a point drawing of a face. When I print the egg the eyes are white althoug in Inkscape I see them in black. Which is the problem?Tatien3DParticipantI am moving the layers because I have to stretch the photo and put the layers in the correct place into the paper. Another question, how can I say to the pen that star the print of the layers in the same point?
Thank youTatien3DParticipantI try to expalin better. I vectorize a photo in grayscales (4). Then I got 4 layers. I want to move them and put them in the same place: x=0, y=20 w=500 h=350 (for instance). But the layers are not stacking and, when I print in my egg, the colours move out.
I can´t expain it better (sorry), I speak Spanish, not English. If I knew how to put here a photo…Tatien3DParticipantI haven an eggbot. The problem is with Inkscape (I think)
-
AuthorPosts
