[TimL]

Thanks Windell! I will take take your advice and investigate the I2C and UART options.
Regarding the “SER” jumper option, wasn’t this was one of the improvements added to the 2.3 Board revision? I am working with a 2.2 Peggy Board so I don’t have the SER JP 1 / JP 2 section above the Prototype area on my board as outlined at step 6 of the manual.
Is there another work around for the 2.2 board to enable Peggy2serial library and use UART, or can I still use I2C without the SER jumper option?
Thanks again!

[TimL]

yes, may have to do that..

otherwise it is a new chip… presuamably they are easy to purchase… will I have to reinstall code on it?

[TimL]

Hi Windell,

Thanks, I think that was it… If you’ve read my edited post above, you’ll see I’ve added to my problems…

Might need to replace the chip before continuing…

Thanks so much for your reply!

TimL

[Author]

Posts